TM-9-2320-283-34-1

TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, M915A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1983

TM-9-2320-283-34-1 - Page 461 of 624

TM 9-2320-283-34-1

TRANSMISSION.

3-43.

GEAR UNIT AND MAINSHAFT REPAIR (Continued).

LOCATION/ITEM

ACTION

REMARKS

C.

ASSEMBLY (Continued).

4.

Sun gear and shaft

assembly (10)

(continued).

CAUTION

If support collar is not used, over-expansion of swaging tool may cause damage to sun gear shaft.

g. Position item (33) on

Use tool No.

J-26997-2.

small end of item (10)

flush with end of shaft.

h. Locate slot of item (33)

approximately 180

°

from

item (31) and tighten

locking screw.

i.

Insert item (29) into item

Use tool number J-26997.

(9).

Tool will rest on end

of item (9).

j.

Aline item (32) with item

(31).

k. Turn item (32) clockwise

until item (29) expands

and stops against item

(9).

l.

Back out item (32) remove

item (29).

m. Loosen locking screw and

remove item (33).

NOTE

Repeat steps h through 1 for opposite end.

Collar is not required.

3-408