TM-9-2320-283-34-2
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, MQ15A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-2 - Page 88 of 570
C. ASSEMBLY
TM 9-2320-283-34-2
REAR TANDEM AXLES.
3-70. FORWARD-REAR AXLE CARRIER REPAIR (Continued).
LOCATION/ITEM
ACTION
REMARKS
NOTE
If ring gear and drive pinion assembly
are to be reused,
install the same
amount and size of shims removed dur-
ing
disassembly.
When installing a
new ring gear and drive pinion assem-
bly, use a nominal shim pack of 0.029
inch.
43. Shims (25).
Place on item (15) and make
Items (25) are available
certain lube hole is clear.
in five different sizes.
The total number and
sizes will be determined
during adjustment.
44. Assembled cage
(21).
Install into item (15).
45. Six screws (23)
Install in item (21) and
Items (23) and assembled
and lockwashers
torque to 155-175 lb-ft.
item (21) may have to
(24).
be removed during final
adjustment for changing
shims.
46. Gear (17).
Install on item (31) using
suitable installation tool.
47. Nut (33).
Install on item (31) and
torque to 780-960 lb-ft.
48. Gear (32) and
Install into item (15).
During installation,
differential wheel
tilt item (30) to allow
cage assembly (1).
differential case
pilot to mesh properly
with edge of bearing
cap pedestal as shown.
49. Two cups (6) and
Install in item (15).
Make certain punch marks
(35), adjusters
are properly alined and
(7) and (34), and
threads of items (7) and
caps (11).
(34) are not cross
threaded with item (11).
3-644
Back to Top
