TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

TM-9-2320-304-14-P - Page 1001 of 1320

TM 9-2320-304-14&P

5-241

Direct Support and General Support Maintenance (Cont)

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give off

harmful vapors, and are harmful to skin

and clothing. To avoid injury or death,

keep away from open fire and use in

well-ventilated area. If adhesive, solvent,

or sealing compound gets on skin or

clothing, wash immediately with soap and

water.

NOTE

There are two pin bracket assemblies.

Both are installed the same way. Right

side is shown.

(79)

Apply sealing compound to threads of

four screws (116).

(80)

Install four screws (116) and pin

bracket (117) on arm assembly (113).

NOTE

•

Grease fitting must be installed so

grease fitting faces towards outside

of vehicle. Plug faces inside of

vehicle.

•

If (CHU) kit short strut comes with

two plugs installed, remove and

discard plug that is replaced by

grease fitting.

(80.1)

Install grease fitting (117.1) and

plug (117.2) in short strut end (117.3).

WARNING

Use care when installing snap rings and

retaining rings. Snap rings and retaining

rings are under spring tension and can act

as projectiles when released and can cause

severe injury.

NOTE

Beveled edge of spacer faces bearing in

short strut.

(81)

Install spacer (118), short strut (119),

pivot pin (120), and retaining ring (121)

on pin bracket (117).