TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

  TM-9-2320-304-14-P - Page 108 of 1320

TM 9-2320-304-14&P
2-46
Operating Instructions (Cont)
2-9. LOAD HANDLING SYSTEM (LHS) (CONT).
(17)
Move joystick (10) to UNLOAD position until flatrack rollers (11) contact reartra
i
lerstops(17)
.
(18)
Release joystick (10).
(19)
Inspect that rear rollers (11) on flatrack have contacted rear trailer stops (17).
(20)
Apply service brake pedal (18).
(21)
Push in truck PARKING BRAKE control (3).
(22)
Turn hydraulic selector switch (9) to MAN H.A.
(23)
Move joystick (10) to UNLOAD position until flatrack is fully seated on trailer.
NOTE
It may be necessary to repeat steps
(24)
through
(26)
several times to clear hook arm from
hook bar.
(24)
Move joystick (10) to LOAD position to allow top of lift hook (19) to clear hook bar (20).
NOTE
Do not move truck forward more than 3 in. (76.2 mm) to prevent flatrack from
pulling away from rear trailer stops.
LHS will only operate when transmission range selector is in N (Neutral).
(25)
Place transmission range selector (4) in D (Drive). Release service brake pedal (18) and move
truck forward approximately 3 in. (76.2 mm). Apply service brake pedal (18).
(26)
Move the joystick (10) to UNLOAD position to disengage lift hook (19) from hook bar (20).
(27)
Set transmission range selector (4) to N (Neutral) and pull out PARKING BRAKE control (3).
Change 2


Back to Top