TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

TM-9-2320-304-14-P - Page 304 of 1320

TM 9-2320-304-14&P

2-82.154

Operating Instructions (Cont)

2-10.11 REMOVING AND INSTALLING FRONT LIFT ADAPTER FROM TRUCK (CONT).

(17)

Start engine (TM 9-2320-279-10).

NOTE

•

To disengage LHS hook arm from front lift adapter hook, it may be necessary to

cycle LHS to unload after driving ahead slightly.

•

LHS will only operate when transmission range selector is in N (Neutral).

•

If ground is soft, jacking plate from truck BII or similar item may be positioned

under support leg pad to prevent front lift adapter from sinking in ground.

(18)

Move joystick (5) to UNLOAD until LHS stops and hook (16) is below front lift adapter hook

bar (17).

(19)

Set transmission range selector (18) to D (Drive) and move truck ahead approximately

12 in. (30 cm).

(20)

Apply service brake pedal (19), set transmission range selector (18) to N (Neutral), and pull out

parking brake knob (20) to apply parking brake.

(21)

Turn hydraulic selector switch (4) to OFF.

(22)

Put PTO ENGAGE switch (2) in OFF position. Make sure indicator light (3) goes off.

(23)

Shut off engine (TM 9-2320-279-10).

Change 2