TM-9-2320-304-14-P

LOAD HANDLING SYSTEM, HEAVY EXPANDED MOBILITY TACTICAL TRUCKS (HEMTT)

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, AND DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2000

TM-9-2320-304-14-P - Page 607 of 1320

TM 9-2320-304-14&P

4-184.5

Organizational Maintenance Instructions (Cont)

(12)

Position sensor plate (8) with two

clamps on hook arm (7) as shown.

(13)

Mark line around sensor plate (8) on

hook arm (7).

(14)

Remove two clamps and sensor plate (8)

from hook arm (7).

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give off

harmful vapors, and are harmful to skin

and clothing. To avoid injury or death,

keep away from open fire and use in

well-ventilated area. If adhesive, solvent,

or sealing compound gets on skin or

clothing, wash immediately with soap and

water.

NOTE

Mix epoxy according to directions on package.

(15)

Mix epoxy and apply to sensor plate (8) and hook arm (7).

NOTE

Epoxy takes approximately 15 minutes to cure.

(16)

Clamp sensor plate (8) to hook arm (7) in position marked until cured.

(17)

Remove clamps from hook arm (7).

(18)

Prime and paint area as necessary (TM 43-0139).

(19)

Install two screws (10),

lockwashers (11), and proximity switch

mount (12) on two clamp halves (13).

(20)

Install CHU proximity switch (14) and

two nuts (15) on proximity switch

mount (12).

Change 1