TM-9-2320-328-13-P-3

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 3 OF 3

MARCH 2009
TM-9-2320-328-13-P-3

  TM-9-2320-328-13-P-3 - Page 63 of 844

TM 9-2320-328-13&P-3
0334-1
DRAFT
0334
FIELD LEVEL MAINTENANCE
LIGHT BEZEL(S) REPLACEMENT
INITIAL SETUP:
REMOVAL
NOTE
All light bezel boxes are removed similarly.
Driver side rear light bezel box shown.
1.
Disconnect upper driver side body wire harness connector (1) from lower driver side body wire harness
connector (2).
2.
Route upper driver side body wire harness (3) through bezel box (4) and hose bed assembly (5).
3.
Remove three nuts (6), lockwashers (7), six washers (8), and screws (9) from bezel box (4) and hose bed
assembly (5).
Discard lockwashers.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
HWT2904A
Tools and Special Tools
Tool Kit, General Mechanic’s: Automotive
(WP 0398, Item 17)
Materials/Parts
Lockwasher (3)
Lockwasher (4)
References
WP 0391, Fig. 29
Equipment Conditions
Hose bed compartment opened (driver side rear
light bezel)(WP 0008)
Equipment Conditions (continued)
SINCGARS antenna bracket removed (driver side
rear light bezel) (TM 11-5820-498-12)
Light bezel cover removed (driver side rear light
bezel) (WP 0335)
Marker/clearance LED removed (driver side rear
light bezel) (WP 0229)
Warning lights removed (driver side rear light
bezel) (WP 0231)
Scene lights removed (driver side rear light
bezel) (WP 0233)


Back to Top