TM-9-2320-344-10

TRUCK, CARGO, GUIDED MISSILE TRANSPORTER (GMT), 8X8, M985A4GMT

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-344-10 - Page 250 of 1012

WARNING

If beam retainer stop is inoperative, beam could be pulled out too far and

fall, resulting in injury to personnel.

3.

Extend outrigger beam (4) by pulling outrigger leg (2) out slowly, until outrigger beam

(4) stops.

4.

Replace outrigger beam retainer pin (3) and beam retainer lock (1) to lock outrigger

beam (4) in place.

5.

Remove outrigger leg retainer lock (5).

WARNING

Failure to hold outrigger leg may cause leg to rotate and fall, resulting in

injury to personnel.

6.

While holding outrigger leg (2), remove outrigger leg pin (6); then slowly rotate outrigger

leg (2) to down position.

7.

Replace outrigger leg pin (6) and retainer lock (5) to secure outrigger leg (2) in down

position.

8.

Repeat Steps (1) through (7) for driver side outrigger.

NOTE

Both outrigger pads are installed on outrigger legs in the same manner.

Passenger side shown.

9.

While holding outrigger pad (7) in place, remove outrigger pad retainer lock (8). Remove

outrigger pad (7) from stowage bracket (9).

TM 9-2320-344-10

0036

0036-8