TM-9-2320-346-10

TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8 M1977A4 W/WINCH AND M1977A4 W/O WINCH

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-346-10 - Page 344 of 1184

CAUTION

•

Do not set HYD ENABLE switch to ON with HIGH IDLE switch ON.

Engaging the HYD ENABLE with HIGH IDLE switch ON may result

in sudden application of hydraulic pressure to the LHS, resulting in

damage to equipment.

•

HYD ENABLE switch must be positioned OFF before road transport,

or severe equipment damage could result.

13. Set HYD ENABLE switch (22) to ON position. MAIN HYD ENABLE indicator light (23)

will illuminate.

WARNING

Trailer wheels must be chocked during transfer operations. Failure to

comply may result in injury or death to personnel.

CAUTION

If transload rollers roll over lifting eyes, damage to the BAP could occur.

NOTE

The amount of time it takes to load and unload is controlled by engine

speed. To reduce loading and unloading times, engine speed can be in-

creased to approximately 1200 rpm by engaging HIGH IDLE switch.

14. Move joystick (24) to UNLOAD until both transload rollers (10) contact trailer (25).

Ensure transload rollers (10) clear the top of trailer lifting eyes (26).

15. Release joystick (24).

16. Ensure trailer guides (27) are between transload rollers (10).

NOTE

If trailer guides are not between transload rollers, perform Step (17). If

trailer guides are aligned, go to Step (18).

17. If trailer guides (27) are not between transload rollers (10):

a.

Move joystick (24) to LOAD.

b.

When the BAP is fully reloaded, release joystick (24). Reposition vehicle to line up

with trailer.

c.

Repeat Steps (9) through (16).

TM 9-2320-346-10

0044

0044-10