TM-9-2320-346-10

TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8 M1977A4 W/WINCH AND M1977A4 W/O WINCH

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-346-10 - Page 754 of 1184

NOTE

Dashboard HIGH IDLE indicator will illuminate when HIGH IDLE switch

is positioned on.

16. Set HIGH IDLE switch (12) to on position.

17. Move joystick (13) to UNLOAD and hold until back edge of the BAP touches the ground.

18. Immediately release service brake pedal (5).

19. Move joystick (13) to UNLOAD and continue unloading while allowing vehicle to roll

forward.

20. Release joystick (13) when front end of the BAP is about 1 ft. (30 cm) off the ground.

NOTE

Dashboard HIGH IDLE indicator will go out when HIGH IDLE switch is

positioned off.

21. Set HIGH IDLE switch (12) to off position.

22. Move joystick (13) to UNLOAD and continue unloading until the BAP rests on the ground

and weight of load is off LHS lifting hook.

NOTE

Dashboard parking brake indicator will illuminate when PARKING

BRAKE control is applied.

23. Apply service brake pedal (5), or pull out PARKING BRAKE control (7).

24. Remove lockpin (14), pin (15), and bail bar lock (16) from LHS lifting hook (17).

16

15

14

17

Figure 6.

25. Move joystick (13) to UNLOAD.

////////////////////////////////////////////////////////////////////////////////////

TM 9-2320-346-10

0108

0108-6

////////////////////////////////////////////////////////////////////////////////////

////////////////////////////////////////////////////////////////////////////////////////////////////////////////////