TM-9-2320-346-10
TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8 M1977A4 W/WINCH AND M1977A4 W/O WINCH
TECHNICAL MANUAL; OPERATOR'S MANUAL
OCTOBER 2008
TM-9-2320-346-10 - Page 747 of 1184
NOTE
Hold joystick in LOAD position until the BAP is loaded.
33. To move and lower hook arm to stowed position, move joystick (11) to LOAD and hold.
WARNING
When NO TRANSIT indicator is illuminated, vehicle may be maneuvered
in the immediate vicinity of the loading/unloading site. However, vehicle
is unsafe for road travel. Do not perform open-road driving when NO
TRANSIT indicator is illuminated. Failure to comply may result in injury
or death to personnel and damage to equipment.
34. Release joystick (11) when hook arm is fully stowed and NO TRANSIT indicator (17)
light goes out.
NOTE
Dashboard HIGH IDLE indicator will go out when HIGH IDLE switch is
positioned off.
35. Set HIGH IDLE switch (10) to off position.
NOTE
Dashboard parking brake indicator will illuminate when PARKING
BRAKE control is applied.
36. Pull out PARKING BRAKE control (4).
CAUTION
While maneuvering vehicle in the immediate vicinity of the loading or un-
loading site, LHS MODE SELECT switch may be in any setting. However,
LHS MODE SELECT switch must be set to OFF prior to road travel, to
prevent damage to main frame and hook arm cylinders.
37. Turn LHS MODE SELECT switch (9) to OFF.
38. Set HYD ENABLE switch (7) to off position. MAIN HYD ENABLE indicator (8) will go
out.
39. Ensure both BAP holddown locks (3) are in auto engage position (handles are pushed
in).
////////////////////////////////////////////////////////////////////////////////////
TM 9-2320-346-10
0107
0107-9
////////////////////////////////////////////////////////////////////////////////////
////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
Back to Top
