TM-9-2320-346-10

TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8 M1977A4 W/WINCH AND M1977A4 W/O WINCH

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-346-10 - Page 759 of 1184

OPERATOR MAINTENANCE

MANUALLY REMOVING LOAD DURING HYDRAULIC POWER LOSS

INITIAL SETUP:

Not Applicable

PERFORM PROCEDURE

NOTE

•

Manual mode operations using the cab CBT control box are to be

performed only when the normal AUTO mode electric circuit is not

operating.

•

This procedure is used to remove the load from a vehicle with a failed

hydraulic system or other failure that prevents operation of the

hydraulic system.

•

Each vehicle is equipped with one slave hydraulic hose. Two hoses

(one from each vehicle) are required.

1.

Move vehicles into position so LHS control boxes (1) of both vehicles are side by side.

1

BASE/A2 MODEL CBT

Figure 1.

////////////////////////////////////////////////////////////////////////////////////

TM 9-2320-346-10

0109

0109-1

////////////////////////////////////////////////////////////////////////////////////

////////////////////////////////////////////////////////////////////////////////////////////////////////////////////