TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 493 of 1207
TM 9-2320-361-20
4-52. CAB PROTECTOR WIRING HARNESS REPLACEMENT (M756A2)
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
APPLICABLE MODELS
REFERENCES (TM)
M756A2
TM 9-2320-361-10
MATERIALS/PARTS
TM 9-2320-361-20P
Two locknuts
EQUIPMENT CONDITION
Lockwasher
Parking brake set (TM 9-2320-361-10).
Safety wire (Appendix C, Item 22)
Battery ground cable disconnected (para. 4-48).
CAUTION
Use care when removing or routing harness. Snagging may result,
and forceful pulling will cause damage to harness.
NOTE
Tag all leads for installation.
1.
2.
3.
4.
5.
Disconnect cab protector wiring harness (2) from two floodlights (5), three clearance light wires (4),
and rear wiring harness (11).
Remove four grommets (3) from cab protector (1) and cab protector wiring harness (2).
Remove locknut (7), screw (16), and clamp (6) from cab protector wiring harness (2) and rear winch
support (8). Discard locknut (7).
Remove locknut (10), screw (13), lockwasher (14), ground terminal (12), and clamp (15) from
crossmember (9) and cab protector wiring harness (2). Discard locknut (10) and lockwasher (14).
Remove cab protector wiring harness (2) from cab protector (1).
b. Installation
1. Install cab protector wiring harness (2) in cab protector (1).
2. Install four grommets (3) on cab protector wiring harness (2) and cab protector (1).
3. Install clamp (15), ground terminal (12), and cab protector wiring harness (2) on crossmember (9)
with new lockwasher (14), screw (13), and new locknut (10).
4. Install clamp (6) on cab protector wiring harness (2) and rear winch support (8) with screw (16) and
new locknut (7).
5. Connect cab protector wiring harness (2) to rear wiring harness (11), three clearance light wires (4),
and two floodlights (5).
4-82
Back to Top
