TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 509 of 1207
TM 9-2320-361-20
6-3. TRANSFER CASE CONTROLS AND LINKAGE MAINTENANCE (W/O PTO)
This task covers:
a. Removal
c. Installation
b. Cleaning and Inspection
INITIAL SETUP:
APPLICABLE MODELS
EQUIPMENT CONDITION
All except M49A2C, M50A2,
Parking brake set (TM 9-2320-361-10).
M50A3, M756A2, and M764
GENERAL SAFETY INSTRUCTIONS
MATERIALS/PARTS
Keep fire extinguisher nearby when using
Three locknuts
drycleaning solvent.
Rags (Appendix C, Item 21)
Drycleaning solvent (Appendix C, Item 26)
REFERENCES (TM)
TM 9-2320-361-10
TM 9-2320-361-20P
1. Remove two locknuts (6), screws (3), rod (1), and clevis (4) from transfer case shaft (5) and transfer
case shift handle (10). Discard locknuts (6).
2.
Loosen jamnut (2) and remove clevis (4) and jamnut (2) from rod (1).
3. Remove locknut (7), screw (9), and transfer case shift handle (10) from transfer case shift
bracket (8). Discard locknut (7).
b. Cleaning and Inspection
WARNING
Drycleaning solvent is flammable and will not be used near open
flame. Use only in well-ventilated places. Failure to do so may
result in injury to personnel.
1. Clean all parts with drycleaning solvent and dry with clean rag.
2. Inspect all parts for breaks, cracks, and bends. If broken, cracked, or bent, replace part.
c. Installation
1.
2.
3.
4.
6-10
Install transfer case shift handle (10) on transfer case shift bracket (8) with screw (9) and new
locknut (7). Shift handle (10) must move freely.
Install jamnut (2) and clevis (4) on rod (1) to measure 4.9 in. (12.4 cm) from center of clevis (4) hole
and rod (1) hole. Tighten jamnut (2).
Install clevis (4) and rod (1) on transfer case shift handle (10) and transfer case shaft (5) with two
screws (3) and new locknuts (6).
Move transfer case shift handle (10) through LOW, NEUTRAL, and HIGH positions and verify
correct installation of controls.
Back to Top
