TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 507 of 1207

TM 9-2320-361-20

6-2. TRANSFER CASE CONTROLS AND LINKAGE MAINTENANCE (W/PTO) (Contd)

d. PTO Lock Adjustment

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

6-8

Ensure transfer case shift handle (10) is in NEUTRAL

Move PTO shift control handle (1) to disengaged position and ensure PTO control lock (3) can be

turned parallel to handle (1) and prevent rearward movement of PTO shift control handle (1).

Remove locknut (13) and ball pivot end (9) from PTO shift lever (5). Discard locknut (13).

NOTE

Perform step 4 on vehicles with transfer case lockout arms.

Remove cotter pin (6), clevis pin (4), and clevis (12) from PTO shift lever (5). Discard cotter pin (6).

Ensure PTO shifter lever (5) is in disengaged position (rear detent).

NOTE

Assistant will help with steps 6 through 9.

Place PTO control lock (3) parallel to handle (1) and hold tight to cab floor (2).

Loosen two jamnuts (8) and adjust (7) to aline ball pivot end (9) to fit freely in PTO shift

lever (5) hole. Tighten two jamnuts (8).

Connect ball pivot end (9) on PTO shift lever (5) with new locknut (13).

NOTE

Perform steps 9 and 10 on vehicles with transfer case lockout arms.

Loosen jamnut (11) and adjust clevis (12) to aline holes in clevis (12) with holes in PTO shift

lever (5). Tighten jamnut (11).

Connect clevis (12) on PTO shift lever (5) with clevis pin (4) and new cotter pin (6).