TM-9-2320-361-20
2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
OCTOBER 1991
TM-9-2320-361-20 - Page 749 of 1207
TM 9-2320-361-20
11-30. FRONT FENDERS MAINTENANCE
This task covers:
a. Removal
c. Installation
b. Inspection and Repair
INITIAL SETUP:
APPLICABLE MODELS
All
MATERIALS/PARTS
Four screw-assembled lockwashers
Thirteen locknuts
Anti-squeak material
Adhesive (Appendix C, Item 1)
REFERENCES (TM)
TB 43-0213
TC 9-510
TM 9-237
TM 9-2320-361-10
EQUIPMENT CONDITION
Parking brake set (TM 9-2320-361-10).
Hood raised and secured (TM 9-2320-361-10).
Front wheels removed (TM 9-2320-361-10).
Side panel removed (para. 11-11).
Front composite lamp housing and brackets
removed (para. 4-41).
Personnel hot water heater removed (left side
only) (para. 11-42).
Exhaust system removed (right side only)
(para. 3-37 or 3-38).
Airhorn removed (right side only) (para. 4-31).
Turn signal flasher removed (left side only)
(para. 4-20).
TM 9-2320-361-20P
NOTE
Right and left fenders are replaced the same. This procedure
covers right side.
1. Remove two screws (30), locknuts (28), clamps (29), and wiring harness (25) from fender
support (21). Discard locknuts (28).
2. Remove three screw-assembled lockwashers (16) from fender (13) and cowl (4). Discard screw-
assembled lockwashers (16).
3. Remove three locknuts (22), screws (26), fender mount springs (27), and nine washers (23) from
fender (13) and fender support (21). Discard locknuts (22).
4. Remove two locknuts (12), screws (7), and washers (6) from light support bracket (10) and
fender (13). Discard locknuts (12).
5. Remove three locknuts (11), washers (9), screws (8), and washers (9) from fender (13) and light
support bracket (10). Discard locknuts (11).
6. Remove screw-assembled lockwasher (19), locknut (14), screw (17), and brace (18) from flame (5).
Discard screw-assembled lockwasher (19) and locknut (14).
NOTE
Assistant will help with step 1.
7. Remove two locknuts (3), screws (15), washers (2), fender (13), and fender mount spacer (24) from
fender support (21), bracket (20), cowl (4), and light support bracket (10). Discard locknuts (3).
8. Remove anti-squeak material (1) from cowl (4). Discard anti-squeak material (1).
11-52
Back to Top
