TM-9-2320-361-20

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; UNIT MAINTENANCE

OCTOBER 1991

TM-9-2320-361-20 - Page 803 of 1207

TM 9-2320-361-20

12-15. DUMP BODY FRONT SPLASH GUARD REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

APPLICABLE MODELS

REFERENCES (TM)

M342A2

TM 9-2320-361-10

MATERIALS/PARTS

TM 9-2320-361-20P

Twelve locknuts

EQUIPMENT CONDITION

Parking brake set (TM 9-2320-361-10).

1. Remove two locknuts (1), screws (7), and brace (8) from front splash guard (6), support (5), and

frame (2). Discard locknuts (1).

NOTE

If replacing right side front splash guard, remove braces from fuel

tank bracket.

2. Remove four locknuts (11), screws (10), and two braces (9) from front splash guard (6) and air

reservoir bracket (12). Discard locknuts (11).

3. Remove three locknuts (1), screws (7), and front splash guard (6) from support (5). Discard

locknuts (1).

4. Remove three locknuts (3), screws (4), and support (5) from frame (2). Discard locknuts (3).

b. Installation

1. Install support (5) on frame (2) with three screws (4) and new locknuts (3).

2. Install front splash guard (6) on support (5) with three screws (7) and new locknuts (1).

NOTE

If replacing right side front splash guard, braces are installed on

fuel tank bracket.

3. Install two braces (9) on front splash guard (6) and air reservoir bracket (12) with four screws (10)

and new locknuts (11).

4. Install brace (8) on front splash guard (6) and frame (2) with two screws (7) and new locknuts (1).

12-20