TM-9-2320-361-24-1

2-1/2 TON, 6X6, M44A2 SERIES TRUCKS

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE PART 1 OF 2

AUGUST 2006

TM-9-2320-361-24-1 - Page 515 of 1176

TM 9-2320-361-24-1

0046 00

0046 00-15

ENGINE REPLACEMENT (Contd)

INSTALLATION (Contd)

WARNING

Keep hands clear of supported engine during placement of engine

mounts. Failure to do so may result in injury to personnel.

13.

Position two mounting pads (20) and (31) on frame (23) and crossmember (30).

14.

Lower engine (1) until it rests on frame (23) and crossmember (30). Ensure mounting holes are aligned.

15.

Install two washers (32), screws (33), lower mounting pads (29), washers (28), and new locknuts (27)

on support plate (10) and crossmember (30). Tighten locknuts (27) 65–70 lb-ft (88–95 N

•

m).

16.

Install two washers (18), screws (17), lower mounting pads (24), washers (25), and new locknuts (26)

on frame (23). Finger-tighten locknuts (26).

17.

Tighten locknuts (26) 65–70 lb-ft (88–95 N

•

m).

18.

Remove lifting device and sling from chain and front lifting bracket (11).

19.

Remove nut (15), screw (12), washers (14) and (13), and chain from rear mounting bracket (16).

NOTE

Perform step 20 if vehicle is equipped with transmission PTO.

20.

Position clevis (22) on PTO arm (19) and push pin (21) in clevis (22) until head of pin (21) seats

against clevis (22).

LIFTING DEVICE

SLING

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

10

32

33

1

11

12

13