TM-9-2320-361-24-2

2-1/2 TON, 6X6, M44A2 SERIES TRUCKS

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE PART 2 OF 2

AUGUST 2006

TM-9-2320-361-24-2 - Page 438 of 1144

TM 9-2320-361-24-2

0315 00

0315 00-2

115- AND 24-VOLT WIRING HARNESS REPLACEMENT (Contd)

CAUTION

Use care when removing wiring harnesses. Excessive snagging

or pulling may damage wires.

NOTE

Prior to removal, tag lead wires, cables, and terminals for

installation.

REMOVAL

NOTE

All three ceiling panels are removed the same. This procedure

covers the removal of one ceiling panel.

1.

Remove ten screws (3) and center ceiling panel (4) from van body ceiling (1).

NOTE

• Safety wire will be used to install new wiring harness. Do not

cut safety wire from spool until harness has been pulled from

van and proper length has been obtained.

• Safety wire must be attached to wires with electrical tape.

2.

Attach safety wire (8) to wires (7), (10), and (11).

3.

Bend tabs (2) out of the way.

4.

Pull wiring harness (6) out of van body rear wall (5).

5.

Remove safety wire (8) from wires (7), (10), and (11). Cut safety wire (8) from spools (9).