TM-9-2320-361-24-2

2-1/2 TON, 6X6, M44A2 SERIES TRUCKS

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE PART 2 OF 2

AUGUST 2006

TM-9-2320-361-24-2 - Page 982 of 1144

TM 9-2320-361-24-2

0455 00

0455 00-24

DIFFERENTIAL CARRIER REPAIR (Contd)

ASSEMBLY AND ADJUSTMENT (Contd)

65.

Install new safety wire (11) on two screws (10).

66.

Install bearing cover (8) and shims (9) on carrier (12) with six new lockwashers (6) and screws (7).

Tighten screws (7) 65–85 lb-ft (88–115 N

•

m).

67.

Remove flange (4) from pinion end of shaft (13).

68.

Perform step 69 if dirt deflectors (5) were removed.

69.

Install two dirt deflectors (5) on two flanges (4).

NOTE

• Apply light coat of GAA grease to splines of flanges before

installation.

• Flanges must be installed with four holes aligned.

• Before tightening nuts, secure flanges in vise.

• Ensure cotter pin holes are aligned before removing carrier

from vise.

70.

Install spacer (14) and two flanges (4) on carrier (12) with two washers (3) and nuts (1). Tighten

nuts (1) 300–600 lb-ft (407–814 N

•

m).

71.

Install two new cotter pins (2) in two nuts (1).