TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 225 of 764

TM 9-2320-361-34

10-4. DIFFERENTIAL CARRIER REPAIR (Contd)

14.

15.

16.

17.

18.

19.

20.

21.

22.

23.

24.

25.

10-8

Remove eight screws (2), lockwashers (1), top cover (3), and gasket (4) from earner (5). Discard

lockwashers (1) and gasket (4).

Remove four screws (9), washers (8), inspection cover (7), and gasket (6) from carrier (5). Discard

gasket (6).

NOTE

Ensure flanges are secured in vise for easy removal of nuts and

washers.

Remove two cotter pins (10), nuts (11), and washers (12) from

shaft

(24). Discard cotter pins (10).

Using mechanical puller, remove two flanges (13) with dirt deflectors (14) from shaft (24).

NOT E

Perform step 18 if dirt deflectors are damaged or flanges require

replacement.

Remove two dirt deflectors (14) from flanges (13).

Remove twelve screws (15), washers (16), front retainer (17), rear retainer (19), and shims (18) from

carrier (5). Record number/thickness of shims (18) removed from front retainer (17) and rear

retainer (19). Tie shims (18) to front retainer (17) and rear retainer (19).

Remove spacer (27) from shaft (24).

Using oil seal remover, remove two oil seals (20) from retainers (17) and (19). Discard oil seals (20).

CAUTION

Use brass drift to remove shaft and bearing seat. Failure to do so

may result in damage to shaft and bearing seat.

Remove shaft (24) and bearing seat (21) through rear of carrier (5).

Remove bearing seat (26) from front of carrier (5).

Remove front bearing (25) and pinion (23) with rear bearing (22) from shaft (24).

Remove rear bearing (22) from hub of pinion (23).