TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 655 of 764

TM9-2320-361-34

17-5. ENGINE COOLANT HEATER COMPONENT BRACKET MAINTENANCE

(Contd)

1. Install receptacle (15) on heater component bracket (13) with four screw-assembled lockwashers (1).

2. Install resistor holder (17) on heater component bracket (13) with screws (17) with nut-

assembled lockwasher (16).

3. Install resistor (18) on resistor holder (17) with screw (19) and nut-assembled lockwasher (16).

4. Install terminal strip (11) on heater component bracket (13) with four screw-assembled lock-

washers (19).

5. Install diode holder (4) on heater component bracket (13) with screw (6).

6. Install diode (5) on diode holder (4) with arrow pointed in direction previously noted.

7. Install resistor leads (2) and (8), diode lead (3), and diode holder (4) on terminal strip (11) with

screw-assembled lockwashers (20), (9), and (7).

1.

Install heater component bracket (30) on heater housing (35) with four screws

(31).

2.

Install leads (26), (27), and (29) on heater component bracket (30) with two screw-assembled

lockwashers (28).

e. Installation

3.

Place grommet (34) on leads (27) and (32) and install on heater housing (35).

4. Install leads (21), (22), (24), and (37) on flame detector switch (36) with three screw-assembled

lockwashers (23).

5.

Install leads (32) and (27) on restriction

thermostat

(33).

6.

Install tiedown strap (25) around wires.

17-12