TM-9-2320-361-34

2-1/2-TON, 6x6, M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

MAY 1992

TM-9-2320-361-34 - Page 677 of 764

TM 9-2320-361-34

17-14. PERSONNEL HEATER FUEL LINE AND BLOWER HOUSING REPLACEMENT

THIS TASK COVERS:

a. Removal

b. Installation

INITIAL SETUP

APPLICABLE MODELS

REFERENCES (TM)

All

TM 9-2320-361-34P

TEST EQUIPMENT

EQUIPMENT CONDITION

Multimeter (Appendix B, Item 3)

Personnel heater igniter removed (para. 17-13).

TOOLS

General mechanic’s tool kit

(Appendix B, Item 1)

Tool kit, electrical (Appendix B, Item 2)

I

a. Removal

1. Loosen nut (3) and remove fuel line (4) from fuel control valve (1).

2. Loosen nut (5) and remove fuel line (4) from burner fuel

inlet (6).

3. Remove blower housing (2) from heat exchanger (7) and heater housing (8).

b. Installation

1.

Place blower housing (2) in heater housing (8).

2. Install fuel line (4) on burner fuel inlet (6) through blower housing (2). Do not fully tighten nut (5).

3. Install fuel line (4) on fuel control

valve (1). Finger tighten nut(3).

17-34