TM-9-2320-362-14-P

TRUCK UTILITY: S250 SHELTER CARRIER, 4X4, M1037 FOR TRAFFIC JAM AN/TLQ-17A(V)3 (HMMWV)

TECHNICAL MANUAL; OPERATOR, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST FOR ELECTRICAL ENVIRONMENTAL SYSTEM (EES)

APRIL 1992

TM-9-2320-362-14-P - Page 202 of 353

TM 9-2320-362-14&P

4-18. EES KIT INSTALLATION (Cont’d)

ii. Ladder Mount Installation

1.

2.

3.

4.

5.

6.

7.

Remove two plastic cap plugs (1) from wheelhouse (6).

Using ladder retaining bracket (4) as a template, align two holes

in ladder retaining bracket (4) with two holes in wheelhouse (6).

Determine center of third hole (5) and remove ladder retaining

bracket (4).

WARNING

●

When drilling,

be sure to wear goggles for eye

protection or injury to personnel may occur.

●

Avoid skin contact with paint, primer, remover,

and thinner particularly if there are cuts or

open wounds on the hand.

Failure to do so

could result in serious injury.

Using 9/32-inch drill bit,

drill hole (5) in wheelhouse (6).

Secure ladder retaining bracket (4) to wheelhouse (6) with

screws (2), washers (3), and self-locking nuts (15).

Install ladder strap assembly (10) to ladder strap bracket (13) and

secure with screws (14) and nuts (12).

Remove two screws (11), washers (8),

and self-locking nuts (7) that

secure tailgate bracket (9) to wheelhouse (6). Remove tailgate

bracket (9) and retain screws (11), washers (8), and self-locking

nuts (7),

Place ladder strap bracket (13) over tailgate bracket (9).

Secure

with two screws (11), washers (8), and self-locking nuts (7).

4-90