TM-9-2320-362-14-P

TRUCK UTILITY: S250 SHELTER CARRIER, 4X4, M1037 FOR TRAFFIC JAM AN/TLQ-17A(V)3 (HMMWV)

TECHNICAL MANUAL; OPERATOR, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST FOR ELECTRICAL ENVIRONMENTAL SYSTEM (EES)

APRIL 1992

TM-9-2320-362-14-P - Page 194 of 353

TM 9-2320-362-14&P

4-18. EES KIT INSTALLATION (Cont’d)

ff. Hand Throttle Cable Installation

1.

2.

3.

4.

5.

6.

7.

8.

9.

4-82

Remove existing hand throttle cable and bracket (TM 9-2320-280-20).

Retain the following items:

(a) Hitch pin (17) and washer (18) that secures clevis (20) to

accelerator rod (19);

(b) Two capscrews (1) and four washers (2) from lower mounting

bracket; and

(c) Capscrew (13), two washers (7), screw (14), and nut (5)

from upper mounting bracket.

Attach hand throttle bracket (8) to instrument panel (9) with

screw (14) and nut (5).

Do not tighten.

Secure hand throttle bracket (8) to instrument panel (9) with

capscrew (13),

two washers (7), and locknut (6).

Tighten screw (14) and nut (5) that secures hand throttle

bracket (8) to instrument panel (9).

Install hand throttle cable (15) to hand throttle bracket (8).

Secure by tightening nut (10) and lockwasher (11) on hand throttle

cable (15).

Install hand throttle cable (15) to throttle cable end

bracket (16).

Tighten two washers (4) and nuts (3) on hand

throttle cable (15).

Install throttle cable end bracket (16) on cowl and secure with

two capscrews (1), four washers (2), and two self-locking

nuts (12).

Secure clevis (20) to accelerator rod (19) with washer (18) and

hitch pin (17).