TM-9-2320-365-20-3

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 3 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-365-20-3 - Page 1028 of 1268

TM 9-2320-365-20-3

15-2

Change 2

Section II.

MAINTENANCE PROCEDURES

15-2.

RESILIENT MOUNT AND MECHANICAL STOP REPLACEMENT

This task covers:

a. Mechanical Stop Removal

b. Mechanical Stop Installation

c. Resilient Mount Removal

d. Resilient Mount Installation

e. Front Angle Bracket Resilient Mount Removal

f.

Front Angle Bracket Resilient Mount Installation

g. Follow-On Maintenance

INITIAL SETUP

Equipment Conditions

Engine shut down (TM 9-2320-365-10).

Cab raised (for front angle bracket resilient mount) (TM

9-2320-365-10).

Tools and Special Tools

Goggles, Industrial (Item 15, Appendix C)

Tool Kit, Genl Mech (Item 44, Appendix C)

Wrench, Torque, 0-175 lb-ft (Item 57, Appendix C)

Tools and Special Tools (Cont)

Crowfoot Attachment, Socket Wrench (Item 5,

Appendix B)

Vise, Machinist (Item 46, Appendix C)

Materials/Parts

Nut, Self-Locking (2) (Item 144, Appendix G)

Washer, Spring (Item 276, Appendix G)

Washer, Spring (Item 280, Appendix G)

a. Mechanical Stop Removal.

Remove two self-locking nuts (1), bolts (2), and mechanical

stop (3) from frame (4).

Discard self-locking nuts.

b. Mechanical Stop Installation.

(1)

Position mechanical stop (3) on frame (4) with two

bolts (2) and self-locking nuts (1).

(2)

Tighten two self-locking nuts (1) to 118-148 lb-ft

(160-201 N•m).

WARNING

Wear appropriate eye protection when

working under vehicle due to the

possibility of falling debris.

Failure to

comply may result in injury to personnel.

NOTE

Both mechanical stops are removed the

same way.

Right rear side shown.

NOTE

Both mechanical stops are installed the same

way.

Right rear side shown.