TM-9-2320-365-20-3

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 3 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-365-20-3 - Page 775 of 1268

TM 9-2320-365-20-3

Change 2

11-21

(4)

Apply grease to inside surface of seal (3).

(5)

Seat seal (3) on adjusting screw (4).

(6)

Install adjusting screw (4) in adjusting sleeve (5).

Back off 1/4 turn.

(7)

Apply film of grease on adjusting sleeve (5).

(8)

Install adjusting sleeve (5) in adjusting plunger (6).

(9)

Apply film of grease on adjusting plunger (6).

(10) Perform steps (4) through (9) for other adjusting

plunger assembly.

e. Installation.

NOTE

(1)

Install anchor plunger (1) in plunger housing (2).

(2)

Position lockwasher (3) and guide screw (4) in

plunger housing (2).

(3)

Tighten guide screw (4) to 15-25 lb-ft (20-34 N

•

m).

(4)

Perform steps (1) through (3) on second anchor

plunger.

CAUTION

CAUTION

•

Ensure adjusting sleeve is installed in

adjusting plunger with large shouldered end

up.

Failure to comply will cause self-

adjusting feature not to function.

•

Adjusting sleeve must bottom on shoulder in

adjusting plunger.

If adjusting screw is

threaded too far into adjusting sleeve,

adjusting screw will bottom in adjusting

plunger and automatic adjustment will not

function.

Align keyway in anchor plunger with hole in

plunger housing.

Anchor plunger marked “L” is for left plunger

housing. Anchor plunger marked “R” is for

right plunger housing. Failure to comply may

result in damage to equipment.