TM-9-2320-365-34-2
M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 2
AUGUST 2005
CHANGE 2
TM-9-2320-365-34-2 - Page 306 of 1414
TM 9-2320-365-34-2
7-2
Change 2
Section II.
MAINTENANCE PROCEDURES
7-2.
TORQUE CONVERTER REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Cleaning/Inspection
d. Assembly
e. Installation
f.
Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Transmission mounted on maintenance stand (para
7-5).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-175 lb-ft. (Item 80, Appendix B)
Gage, Profile (TM 9-2320-365-20)
Caliper, Vernier (Item 8, Appendix B)
Caliper, Micrometer (Item 7, Appendix B)
Straight Edge (Item 61, Appendix B)
Gage Set, Telescoping (Item 21, Appendix B)
Gage, Depth, Micrometer (Item 22, Appendix B)
Pan, Drain (Item 36, Appendix B)
Inserter, Bearing and Bushing (TM 9-2320-365-20)
Socket Wrench Attachment, Screwdriver (Item 53,
Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Gloves, Rubber (Item 23, Appendix B)
Chain, Welded (TM 9-2320-365-10)
Adapter (3/8 to 1/2") (NSN 5120-01-335-0701)
Tools and Special Tools (Cont)
Socket Wrench Attachment, Screwdriver (3/4 Hex,
1/2 Drive) (NSN 5120-01-367-3468)
Materials/Parts
Packing, Retainer (Item 217, Appendix F)
Washer, Seal (Item 300, Appendix F)
Sealring (Item 281, Appendix F)
Spring, Flat (13) (Item 290, Appendix F)
Packing, Retainer (Item 216, Appendix F)
Bolt, Machine (2) (Item 15, Appendix C)
Washer, Flat (2) (Item 92, Appendix C)
Rag, Wiping (Item 59, Appendix C)
Solvent, Dry Cleaning (Item 81, Appendix C)
Lubricating Oil, Engine (Item 48, Appendix C)
Personnel Required
(2)
a. Removal.
(1)
Rotate transmission on maintenance stand so that
torque converter module (1) is in up position.
(2)
Remove retaining ring (2) from torque converter
module (1).
WARNING
Use care when removing retaining rings.
Retaining rings are under tension and can
act as projectiles when released.
Failure
to comply may result in injury to
personnel.
NOTE
Perform
steps
(2)
through
(6)
on
transmissions
prior
to
serial
number
6510165560.
Back to Top
