TM-9-2320-366-10-2
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; OPERATOR’S INSTRUCTIONS; VOLUME NO. 2 OF 2
AUGUST 2005
CHANGE 2
TM-9-2320-366-10-2 - Page 543 of 930
TM 9-2320-366-10-2
Change 2
3-44.1/(3-44.2 Blank)
Table 3-2.
Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
e22.
HIGH ENGINE TEMPERATURE INDICATOR DOES NOT OPERATE (CONT).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-27c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-27c).
(g)
Install PDP cover (para 3-17b).
(h)
If high engine temperature indicator still does not operate, notify Unit Maintenance.
e22A.
HIGH ENGINE TEMPERATURE INDICATOR ILLUMINATES.
Does WATER TEMP gage read below 216°F (102°C) when high engine temperature indicator
illumiantes?
(a)
Start engine (para 2-27a or b).
If WATER TEMP gage does not read above 216°F (102°C), notify Unit Maintenance.
If WATER TEMP gage does read above 216°F (102°C), perform Cooling System Troubleshooting
(d1.
Engine Overheats).
(b)
Shut down engine (para 2-27f).
e23.
CENTRAL TIRE INFLATION SYSTEM (CTIS) OVERSPEED INDICATOR DOES NOT
OPERATE.
Check circuit breaker (CB40) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-17a).
(b)
Position main light switch to OFF (para 2-27c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-27c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-27c).
(g)
Install PDP cover (para 3-17b).
(h)
If CTIS overspeed indicator still does not operate, notify Unit Maintenance.
e24.
CHEMICAL DETECTOR INDICATOR DOES NOT OPERATE.
Check circuit breaker (CB30) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-17a).
Back to Top
