TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1049 of 1824
VOLTAGE TEST
TM 9-2320-366-20-1
Change 1
2-604.117
Use care when testing electrical connectors not
to bend connector pins or damage connector
sockets with multimeter probes.
Failure to
comply may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
Check that
connector pins are not pushed back and
are capable of making good contact.
M1085/M1086/M1096
E17
E52
M1089
Model
Splice
Table 2-12.9.
M1085/M1086/M1089/M1096
RH Side and Rear Marker Light Splices
(1) Disconnect RH rear marker light connector
from connector P89.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector P89.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10) and note reading on
multimeter.
(6) Position main light switch to OFF
(TM 9-2320-366-10-1).
(7) Is 12 VDC is not present, repair wire 489
from connector P89 to splice (refer to Table
2-12.9.
M1085/M1086/M1089/M1096 RH
Side And Rear Marker Lights Splices) (para
2-45) and go to step 9 of this fault if
required or replace M1086/M1089 rear
lights cable assembly (para 7-104) or
M1085/M1096 rear lights cable assembly
(para 7-84) and go to step 1 of this fault.
(8) If 12 VDC is present, replace RH rear
marker light (para 7-38) and go to step 9
of this fault if required.
(9) Connect RH rear marker light connector
to connector P89.
CAUTION
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuits, or
cause severe burns or electrical shock.
WARNING
Back to Top
