TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1043 of 1824
M1085/M1086/M1096
M1089
E16
E51
Change 1
2-604.111
TM 9-2320-366-20-1
Model
Splice
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
Check that
connector pins are not pushed back and
are capable of making good contact.
NOTE
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuits, or
cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors not
to bend connector pins or damage connector
sockets with multimeter probes.
Failure to
comply may result in damage to equipment.
(1) Disconnect LH rear marker light connector
from connector P86.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector P86.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) Position main light switch to OFF (TM
9-2320-366-10-1).
(7) Is 12 VDC is not present, repair wire 489
from connector P86 to splice (refer to
Table 2-12.8.
M1085/M1086/M1089/
M1096 LH Side And Rear Marker Lights
Splices) (para 2-45) and go to step 8 of this
fault if or replace M1086/M1089 rear lights
cable assembly (para 7-104) or M1085/
M1096 rear lights cable assembly
(para 7-84) and go to step 1 of this fault.
(8) If 12 VDC is present, replace LH rear
marker light (para 7-38) and go to step 8
of this fault if required.
VOLTAGE TEST
(9) Connect LH rear marker light connector to
connector P86.
Table 2-12.8.
M1085/M1086/M1089/M1096 LH
Side and Rear Marker Light Splices
Back to Top
