TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1051 of 1824

CONTINUITY TEST

Change 1

2-604.119

TM 9-2320-366-20-1

If vehicle is not M1089, repair wire 3094 from

terminal lug TL32 to splice E21 (para 2-45)

and go to step 10 of this fault if required or

replace M1086 rear lights cable assembly

(para 7-104) or M1085/M1096 rear lights cable

assembly (para 7-84) and go to step 1 of this

fault.

(1)

Remove nut, lockwasher, terminal lug TL30,

and lockwasher from LH rear marker light

screw.

Discard lockwashers.

(2)

Set multimeter to ohms.

(3)

Connect positive (+) probe of multimeter

to terminal lug TL30.

(4)

Connect negative (-) probe of multimeter to

to ground and note reading on multimeter.

(5)

If continuity is not present, repair wire

3094 from terminal lug TL30 to terminal

lug TL92 (para 2-45) and go to step 10 of

this fault if required or replace M1089 rear

lights cable assembly (para 7-104) and go

to step 1 of this fault.

(6)

If continuity is present, repair wire 489

from splice E49 to splice E50 (para 2-45)

and go to step 10 of this fault if required or

replace M1089 rear lights cable assembly

(para 7-104) and go to step 1 of this fault.

(7)

Install lockwasher, terminal lug TL30,

lockwasher, and nut on LH rear marker

light screw.