TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1079 of 1824

Change 1

2-604.147

TM 9-2320-366-20-1

VOLTAGE TEST

M1085/M1086/M1096

M1089

E17

E52

WARNING

CAUTION

Model

Table 2-12.15.

M1085/M1086/M1089/M1096

RH Side and Rear Marker Light Splices

Splice

(1) Disconnect RH side marker light connector

from connector P88.

(2) Set multimeter to volts DC.

(3) Connect positive (+) probe of multimeter

to connector P88.

(4) Connect negative (-) probe of multimeter to

ground.

(5) Position main light switch to SER DRIVE

(TM 9-2320-366-10-1) and note reading

on multimeter.

(6) Position main light switch to OFF

(TM 9-2320-366-10-1).

(7) Is 12 VDC is not present, repair wire 489

from connector P88 to splice (refer to Table

2-12.15.

M1085/M1086/M1089/M1096

RH Side And Rear Marker Light Splices)

(para 2-45) and go to step 9 of this fault if

required or replace M1086/M1089 rear

lights cable assembly (para 7-104) or

M1085/M1096 rear lights cable assembly

(para 7-84) and go to step 1 of this fault.

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE

Use care when testing electrical connectors not

to bend connector pins or damage connector

sockets with multimeter probes.

Failure to

comply may result in damage to equipment.

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuits, or

cause severe burns or electrical shock.