Change 1
2-604.149
TM 9-2320-366-20-1
CONTINUITY TEST
(1)
Remove nut, lockwasher, terminal lug TL19,
and lockwasher from RH side marker light
screw.
Discard lockwashers.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter
to terminal lug TL19.
(4)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5)
If continuity is not present, repair wire
3095 from terminal lug TL19 to terminal
lug TL20 (para 2-45) and go to step 9 of
this fault if required or replace M1086/
M1089 rear lights cable assembly
(para 7-104) or M1086/M1096 rear lights
cable assembly (para 7-84) and go to step 1
of this fault.
(6)
If continuity is present, replace RH side
marker light (para 7-38) and go to step 9
of this fault if required.
(7)
Install lockwasher, terminal lug TL19,
lockwasher, and nut on RH side marker
light screw.
(8)
Connect RH side marker light connector
to connector P88.