TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006
CHANGE 3

  TM-9-2320-366-20-1 - Page 1083 of 1824

CONTINUITY TEST
Change 1
2-604.151
TM 9-2320-366-20-1
CONTINUITY TEST
(1)
Remove nut, lockwasher, terminal lug TL30,
and lockwasher from LH rear marker light
screw.
Discard lockwashers.
(2)
Remove nut, lockwasher, terminal lug TL31,
and lockwasher from middle rear marker light
screw.
Discard lockwashers.
(3)
Set multimeter to ohms.
(4)
Connect positive (+) probe of multimeter
to terminal lug TL30.
(5)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(6)
If continuity is not present, repair wire
3094 from terminal lug TL30 to terminal
lug TL31 (para 2-45) and go to step 11 of
this fault if required or replace M1086
rear lights cable assembly (para 7-104)
or M1085/M1096 rear lights cable
assembly (para 7-84) and go to step 1
of this fault.
(7)
Install lockwasher, terminal lug TL30,
lockwasher, and nut on LH rear marker
light screw.
(1)
Remove nut, lockwasher, terminal lug TL32,
and lockwasher from RH rear marker light
screw.
Discard lockwashers.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter
to terminal lug TL31.
(4)
Connect negative (-) probe of multimeter to
terminal lug TL32 and note reading on
multimeter.
(5)
If continuity is not present, repair wire
3094 from terminal lug TL31 to terminal
lug TL32 (para 2-45) and go to step 11 of
this fault if required or replace M1086 rear
lights cable assembly (para 7-104) or
M1085/M1096 rear lights cable assembly
(para 7-84) and go to step 1 of this fault.
(6)
If continuity is present, replace LH rear
marker light (para 7-38) and go to step 11
of this fault if required.
(7)
Install lockwasher, terminal lug TL32,
lockwasher, and nut on RH rear marker
light screw.
(8)
Install lockwasher, terminal lug TL31,
lockwasher, and nut on middle rear
marker light screw.


Back to Top