TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1211 of 1824

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

2-657

2-657

2-657

2-657

2-657

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuit

and cause severe burns or electrical shock.

WARNING

VOLTAGE TEST

(13)

Connect connector P65 to connector J65.

(14)

Install kick panel (para 16-3).

(1)

Remove seven screws and washers from kick

panel.

(2)

Remove kick panel and stiffener from dashboard.

(3)

Disconnect connector P65 from connector

J65.

(4)

Set multimeter to volts dc.

(5)

Connect positive (+) probe of multimeter to

connector J65-1.

(6)

Connect negative (-) probe of multimeter to

ground.

(7)

Position main light switch to SER DRIVE

(TM 9-2320-366-10-1).

(8)

Position warning light switch to on

(TM 9-2320-366-10-1).

(9)

If 12 vdc is not present, repair wire 509

(para 2-45) or replace WTEC II dashboard cable

assembly (para 7-10) or WTEC III dashboard

cable assembly (para 7-11).

(10)

If 12 vdc is present, repair wire 509

(para 2-45) or replace warning light cable

assembly (para 22-5).

(11)

Position warning light switch to off

(TM 9-2320-366-10-1).

(12)

Position main light switch to OFF

(TM 9-2320-366-10-1).