TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1213 of 1824
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
2-659
2-659
2-659
2-659
2-659
VOLTAGE TEST
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
WARNING
CONTINUITY TEST
(1)
Disconnect warning light connector from
connector J44 (left) or J45 (right).
(2)
Set multimeter to volts dc.
(3)
Connect positive (+) probe of multimeter to
connector J44-B (left) or J45-B (right).
(4)
Connect negative (-) probe of multimeter to
ground.
(5)
Position main light switch to SER DRIVE
(TM 9-2320-366-10-1).
(6)
Position warning light switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If 12 vdc is not present, go to step 4 of this
fault.
(8)
Position warning light switch to off
(TM 9-2320-366-10-1).
(9)
Position main light switch to OFF
(TM 9-2320-366-10-1).
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
connector J44-A (left) or J45-A (right).
(3)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4)
If continuity is not present, go to step 5 of
this fault.
(5)
If continuity is present, replace M1089 amber
warning light assembly (para 22-2).
(6)
Connect connector J44 (left) or J45 (right) to
warning light connector.
Back to Top
