(1) Set multimeter to volts ohms.
(2) Connect positive (+) probe of multimeter
to diode D1B terminal 3 (LH) or diode D2A
terminal 1 (RH).
(3) Connect negative (-) probe of multimeter to
connector J51 pin 5 (LH) or pin 4 (RH) and
note reading on multimeter.
(4) If continuity is not present, repair wire
461B from connector J51 pin 5 to diode
D1B terminal 3 (LH) or wire 460B from
connector J51 pin 4 to diode D2A terminal
1 (RH) or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(5) Connect connector J51 to connector P51.
(6) Install PDP on dashboard with three
(7) Install three washers and screws in PDP.
(8) Install diode D1B (LH) or diode D2A (RH)
(9) Install PDP cover (para 16-2).
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
connector pins are not pushed back and
are capable of making good contact.
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes.
Failure to comply
may result in damage to equipment.