TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1459 of 1824
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
2-895
2-895
2-895
2-895
2-895
VOLTAGE TEST
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
WARNING
(1)
Remove PDP cover (para 16-2).
(2)
Remove three screws and washers from PDP.
(3)
Remove three screws from PDP.
(4)
Lift PDP outward to gain access.
(5)
Disconnect connector PX22 from windshield
wiper motor.
(6)
Set multimeter to volts dc.
(7)
Connect positive (+) probe of multimeter to
connector PX22-3.
(8)
Connect negative (-) probe of multimeter to
ground.
(9)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(10)
If 24 vdc is not present, go to step 4 of
this fault.
(11)
Position master power switch to off
(TM 9-2320-366-10-1).
Back to Top
