TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1471 of 1824
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
2-907
2-907
2-907
2-907
2-907
CONTINUITY TEST
CONTINUITY TEST
(1)
Remove instrument panel assembly for
access (para 7-15).
(2)
Disconnect windshield wiper ECU from
connector PX21.
(3)
Disconnect connector P18 from turn signal
switch connector.
(4)
Set multimeter to ohms.
(5)
Connect positive (+) probe of multimeter to
connector PX21-1.
(6)
Connect negative (-) probe of multimeter to
connector P18-9 and note reading on
multimeter.
(7)
If continuity is not present, repair wire 1599
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
turn signal switch connector terminal 9.
(3)
Connect negative (-) probe of multimeter to
turn signal switch connector terminal 5.
(4)
Position windshield wiper switch to intermittent
(TM 9-2320-366-10-1) and note reading on
multimeter.
(5)
If continuity is not present, replace turn
signal switch (para 7-26).
(6)
Position windshield wiper switch to off
(TM 9-2320-366-10-1).
(7)
Connect windshield wiper ECU to
connector PX21.
(8)
Connect connector P18 to turn signal switch
connector.
(9)
Install instrument panel assembly (para 7-15).
(10)
Install PDP on dashboard with three screws.
(11)
Install three washers and screws in PDP.
(12)
Install PDP cover (para 16-2).
Back to Top
