TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1475 of 1824

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

2-911

2-911

2-911

2-911

2-911

VOLTAGE TEST

Remove rings, bracelets, watches,

necklaces, and any other jewelry

before working around vehicle.

Jewelry can catch on equipment

and cause injury or short across

electrical circuit and cause severe

burns or electrical shock.

WARNING

(1)

Remove PDP cover (para 16-2).

(2)

Remove three screws and washers from PDP.

(3)

Remove three screws from PDP.

(4)

Lift PDP outward to gain access.

(5)

Disconnect connector PX22 from windshield

wiper motor.

(6)

Set multimeter to volts dc.

(7)

Connect positive (+) probe of multimeter to

connector PX22-4.

(8)

Connect negative (-) probe of multimeter to

ground.

(9)

Position master power switch to on

(TM 9-2320-366-10-1).

(10)

Position windshield wiper switch to high

(TM 9-2320-366-10-1) and note reading on

multimeter.

(11)

If 24 vdc is not present, go to step 2 of this

fault.

(12)

If 24 vdc is present, replace windshield

wiper motor (para 18-4).

(13)

Position windshield wiper switch to off

(TM 9-2320-366-10-1).

(14)

Position master power switch to off

(TM 9-2320-366-10-1).

(15)

Connect connector PX22 to windshield

wiper motor.