TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 493 of 1824

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

NOTE

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

TM 9-2320-366-20-1

Change 1

2-322.1

(1)

Connect connector PX9 to fuel gage

connector.

(2)

Connect connector clamp on fuel gage

connector.

(3)

Install instrument panel assembly

(para 7-15).

(4)

Set multimeter to ohms.

(5)

Connect positive (+) probe of multimeter

to connector P82 socket 2.

(6)

Connect negative (-) probe of multimeter

to a known good ground and note

reading on multimeter.

(7)

If continuity is not present, repair wire

3001 from connector P82 socket 2 to

terminal lug TL83 (para 2-45) or replace

start and charging cable assembly

(para 7-132).

(8)

If continuity is present, replace fuel level

sensor (para 4-8).

(9)

Connect connector P82 to fuel level

sensor.

(10)

Connect connector clamp on fuel level

sensor.

CONTINUITY TEST