TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 499 of 1824

RESISTANCE TEST

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter

to connector PX11 pin 4.

(3)

Connect negative (-) probe of multimeter

to a known good ground and note

reading on multimeter.

(4)

If less than 750 ohms is present, go to

step 3 of this fault.

(5)

If greater than 750 ohms is present,

replace WATER TEMP gage (para 7-14).

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back or not

capable of making good contact.

NOTE

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

TM 9-2320-366-20-1

Change 1

2-326.1