TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 503 of 1824

CONTINUITY TEST

NOTE

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back or not

capable of making good contact.

CAUTION

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

(10)

Install instrument panel assembly (para 7-15).

(1)

Disconnect connector J31 from connector

P31.

(2)

Set multimeter to ohms.

(3)

Connect positive (+) probe of multimeter

to connector PX11 pin 4.

(4)

Connect negative (-) probe of multimeter

to connector J31 pin 20 and note reading on

multimeter.

(5)

If continuity is not present, repair wire

33 from connector PX11 pin 4 to connector

J31 pin 20 (para 2-45) or replace WTEC II

dashboard cable assembly (para 7-10) or

WTEC III dashboard cable assembly

(para 7-11).

(6)

If continuity is present, repair wire 33 from

connector P31 socket 20 to connector P41

(para 2-45) or replace engine control

cable assembly (para 7-80).

(7)

Connect connector J31 to connector P31.

(8)

Connect connector PX11 to WATER

TEMP gage connector.

(9)

Connect connector clamp on WATER

TEMP gage connector.

TM 9-2320-366-20-1

Change 1

2-327