TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 491 of 1824

RESISTANCE TEST

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

NOTE

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

CONTINUITY TEST

TM 9-2320-366-20-1

Change 1

2-321

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter

to connector PX9 pin 4.

(3)

Connect negative (-) probe of multimeter

to a known good ground and note

reading on multimeter.

(4)

If greater than 30 ohms is present, replace

FUEL gage (para 7-14).

(1)

Disconnect connector clamp from fuel level

sensor.

(2)

Disconnect connector P82 from fuel level

sensor.

(3)

Set multimeter to ohms.

(4)

Connect positive (+) probe of multimeter

to connector PX9 pin 4.

(5)

Connect negative (-) probe of multimeter

to connector P82 pin 1 and note

reading on multimeter.

(6)

If continuity is not present, go to step 5 of

this fault.