TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 901 of 1824

Change 1

2-586.1

TM 9-2320-366-20-1

Terminal Lug

Wire Segment

Table 2-11.2.

Cab Clearance and Marker Light Terminal Lugs

Light

RH Cab Top Marker Light

RH Cab Top ID Light

TL3

TL3 to splice E24

TL4 to splice E24

TL4

Middle Cab Top ID Light

TL8

TL8 to splice E24

LH Cab Top ID Light

TL22

TL22 to splice E24

TL27 to splice E24

TL27

LH Cab Top Marker Light

CONTINUITY TEST

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter to

terminal lug (Refer to Table 2-11.2.

Cab

Clearance and Marker Light

Terminal Lugs).

(3)

Connect negative (-) probe of multimeter to

to ground and note reading on multimeter.

(4)

If continuity is not present, repair wire 3097

(para 2-45) or replace cab clearance and

marker lights cable assembly (para 7-66)

or M1093/M1094 cab clearance and marker

lights upper cable assembly (para 7-63).

(5)

If continuity is present, replace marker light

assembly (para 7-38).

(6)

Install gasket on marker light base.

(7)

Connect connector (Refer to Table 2-11.2.

Cab Clearance and Marker Light

Connectors) to marker light connector.

(8)

Install lockwasher, terminal lug (Refer to

Table 2-11.2. Cab Clearance and

Marker Light Terminal Lugs),

lockwasher, and nut on back of base.

(9)

Install marker light base on vehicle with four

screws.

(10)

Install marker light lamp in socket.

(11)

Install lens cover on base with two screws.