TM-9-2320-366-20-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-2 - Page 603 of 1632

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

NOTE

CONTINUITY TEST

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

TM 9-2320-366-20-2

Change 1

2-1450.25

(1) Disconnect batteries (para 7-57).

(2) Remove kick panel (para 16-3).

(3) Disconnect connector J108 from connector

P108.

(4) Remove circuit breaker CB50 from PDP.

(5) Set multimeter to ohms.

(6) Connect positive (+) probe of multimeter

to connector J108 pin 16.

(7) Connect negative (-) probe of multimeter to

circuit breaker CB50 socket 2 and note

reading on multimeter.

(8) If continuity is not present, go to step 17 of

this fault.