TM-9-2320-366-20-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-2 - Page 607 of 1632

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

NOTE

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

TM 9-2320-366-20-2

Change 1

2-1451

CONTINUITY TEST

(1) Remove personnel heater for access

(para 18-9).

(2) Disconnect connector P912 from connector

J912.

(3) Set multimeter to ohms.

(4) Connect positive (+) probe of multimeter

to connector J108 pin 16.

(5) Connect negative (-) probe of multimeter to

connector J912 pin/socket 1 and note

reading on multimeter.

(6) If continuity is not present, repair wire

2006 from connector J108 pin 16 to

connector J912 socket 1 (para 2-45) or

replace auxiliary panel cable assembly

(para 7-58).

(7) If continuity is present, repair wire 2006

from circuit breaker CB50 socket 2 to

connector P912 pin 1 (para 2-45) or

replace WTEC II dashboard cable assembly

(para 7-10) or WTEC III dashboard cable

assembly (para 7-11).

(8) Connect connector P912 to connector

J912.

(9) Install personnel heater (para 18-9).

(10) Connect connector J108 to connector

P108.

(11) Install circuit breaker CB50 in PDP.

(12) Install kick panel (para 16-3).

(13) Install wrecker control panel top cover

(para 14-4).

(14) Connect batteries (para 7-57).