TM-9-2320-366-20-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-2 - Page 733 of 1632

TM 9-2320-366-20-2

(1)

Remove six screws from auxiliary panel.

(2)

Lift auxiliary panel from auxiliary panel

housing to gain access.

(3)

Disconnect connector P905 from

worklights switch.

(4)

Set multimeter to volts DC.

(5)

Connect positive (+) probe of multimeter

to connector P905 socket 5.

(6)

Connect negative (-) probe of multimeter

to ground.

(7)

Position main light switch to STOP LIGHT

(TM 9-2320-366-10-1) and note reading

on multimeter.

(8)

If 12 VDC is not present, go to step 7 of

this fault.

(9)

Position main light switch to OFF

(TM 9-2320-366-10-1).

Change 1

2-1541

VOLTAGE TEST

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuits

and cause severe burns or electrical shock.

WARNING