TM 9-2320-366-20-3
b. Installation.
(1) Position terminal lug TL12 (1) on starter solenoid (2) with
nut (3).
(2) Tighten nut (3) to 15-20 lb-ft (20-27 N·m).
WARNING
Adhesives, solvents, and sealing com-
pounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. Keep away from open fire
and use in a well-ventilated area.
If
adhesive, solvent, or sealing compound
gets
on
skin
or
clothing,
wash
immediately with soap and water. Failure
to
comply
may
result
in
injury
to
personnel.
(3) Apply adhesive to terminal lug TL12 (1) on starter
solenoid (2).
NOTE
Both clamps are installed the same way.
One shown.
(4) Install two clamps (4) on battery to starter cable
assembly (5).
NOTE
Steps (5) through (7) require
the aid of an assistant.
(5) Position battery to starter cable assembly (5) on frame
rail (6) with clamp (4), screw (7) and self-locking nut (8).
(6) Perform Step (5) on remaining clamp.
NOTE
Install plastic cable ties as required.
(7) Tighten two self-locking nuts (8) to 97-124 lb-in. (11-14
N·m).
Change 1
7-353